Common Problems with Honda Air Blade Scooters and How to Resolve Them

Honda Air Blade is a popular scooter model among Vietnamese consumers for several reasons. However, like any other vehicle, it may encounter certain issues and quirks. Being aware of these issues can help Air Blade users avoid being overcharged at motorbike repair shops. Below, we have compiled a list of 10 common issues with the Air Blade scooter, based on user feedback and insights from Honda engineers.

Honda Air Blade Experiences Jerking Sensation during Acceleration

Issue: Honda Air Blade jerks strongly in the morning when the engine is turned on and the user accelerates. Additionally, the scooter vibrates and the rider experiences strong vibrations when twisting the throttle from 0 to 20 km/h.

How to resolve the issue of Air Blade jerking during acceleration

• A quick temporary solution for the issue of Air Blade jerking during acceleration is to place the center stand, apply the rear brake, and twist the throttle forcefully once or twice. This solution provides temporary smoothness to the scooter for a short duration, but the issue may reoccur.
• For a long-term solution to the issue of jerking and vibration in the Air Blade, it is recommended to visit reputable repair shops and have them inspect the clutch system of the scooter. If necessary, replace the clutch set and the clutch cover if any signs of wear are found.

Honda Air Blade Engine Cover Rattling

This issue can be resolved by replacing the engine oil with 75W-90 viscosity oil from brands like Eni or Liqui. Engine cover rattling is not exclusive to Air Blade, as many popular scooter models in Vietnam, including Piaggio models like Zip or LX, and even the expensive SH scooter from Honda, experience the same issue.

Honda Air Blade Feels Heavy and Slow to Accelerate

Causes and Solutions:

– Worn clutch housing can be fixed by promptly replacing it.

– Check the tire pressure as excessively hard tires can cause sluggishness due to increased contact area between the tires and the road, eventually leading to clutch housing wear if left unchecked.

– Stuck brakes can also contribute to the heaviness. In such cases, the brakes become excessively hot after some time, and the scooter feels heavy when pushed back and forth. To resolve this, check the brakes (master cylinder, brake fluid, and brake disc).

Honda Air Blade Tilts when Turning Left

Issue: The scooter tilts to one side when making left turns. The main cause is stuck front disc brakes. To fix this issue, bleed the brake fluid and check the brake caliper.

Honda Air Blade Makes Rattling Noise

Issue: When riding the Honda Air Blade at a speed of about 40 km/h, a rattling sound can be heard from the engine, especially when passing over road drains. The knocking sound may be heard near the footrest area.

This sound can be mistakenly attributed to clutch noise, but it is actually from the camshaft inside the engine. To fix this issue, visit a Honda service center and request a readjustment of the camshaft, which is a quick and simple process that takes about 15 minutes.

Vibrations and Heaviness on the Honda Air Blade Floor

Check the footrest bolts and axle. If loose, tighten them. After cleaning the rear bearing or replacing it, ensure proper cleaning of the kick pedal rubber. These steps should eliminate vibrations and the feeling of heaviness.

Honda Air Blade Makes Creaking Noise

Issue: When accelerating, a creaking noise can be heard from the rear wheel of the Honda Air Blade. The noise is also noticeable while riding over speed bumps.

This issue is caused by the rim and is commonly observed in Honda motorcycles in Vietnam, including the SH scooter. The service center may suggest replacing the rim to fix it, but this will not provide a long-term solution, and the issue may recur. A simple fix is to close the 6 spoke holes, which provides a permanent solution to this commonly encountered issue with the Air Blade. Be cautious to avoid unnecessary expenses!

Honda Air Blade Engine Stalls on Startup

Engine stalling is a common issue with Honda Air Blade scooters. If your scooter stalls consistently and doesn’t produce any rattling noise, it is likely due to misalignment in the electric starter clutch.

If your scooter stalls unevenly, produces two distinct noises, or exhibits the symptoms mentioned previously, along with a rattling noise at startup, then your scooter’s drive belt may be slipping. The fix for this issue is to adjust the primary drive or replace the drive belt (even new scooters can experience this issue).

Honda Air Blade Lacks Power during Acceleration

Since 2014, Honda Air Blade scooters have been facing this issue, which is caused by problems with the fuel injector and the main IC. In most cases, the only solution is to replace the fuel injector with the Vietnamese version found in the Honda SH scooter.

Temporary Engine Cutoff Issue on Honda Air Blade (Idling Stop)

Some users encounter issues with the Idling Stop system of the Air Blade scooter. Occasionally, when the red light is on and the Idling Stop button is activated, the scooter stops running for more than 3 seconds, but the engine remains on. If the side stand is completely lowered, the engine turns off completely. However, if the side stand is lowered halfway, the Idling Stop system functions normally. When facing this situation, it is advisable to visit the service center to check the IC and the contact points of the side stand or Idling button for any rust or poor contact.

With this compilation of the 10 common issues and their solutions for Honda Air Blade scooters, we hope that readers will pay more attention to their scooters and make informed decisions when seeking repair and maintenance services, in order to avoid unnecessary expenses.